Send Message
news

Base Station Radiation

April 7, 2022

    Our country is very strict on the power setting of the communication base station, which is much higher than the STANDARD of the US and the EU, only 40 microwatts per square centimeter, while the US standard is 600 microwatts per square centimeter, fully 15 times higher than our country.

    The hair dryer that we normally use is about 100 microwatts per square centimeter at your head. Your wireless router at home gets about 60 microwatts per square centimeter of radiation when it's about a meter away from you.

Induction cooker is even more scary when you distance from the induction cooker, The amount of radiation produced is a staggering 580 microwatts per square centimwter.

    Why Americans set the radiation standard at 600 microwatts per square centimeter, I think it may be because Americans especially like to cook with induction cookers.

  In fact, when the distance between you and the electrical appliance increases, the amount of radiation decreases rapidly. If you pull 30 centimeters away, the radiation will drop a hundredfold.

  Therefore, the radiation of the mobile phone close to your forehead will be much greater than that of the base station. The power of the mobile phone is indeed very low, but it is too close to you.

  By the way, when the base station signal is weak, the mobile phone will automatically increase the antenna transmission power to capture the signal, and the radiation to you may reach the level of 50 microwatts per square centimeter.

  This data is slightly higher than the national standard, but far lower than the European and American standards, so you don't have to worry about your mobile phone causing harm to you.

  However, those who try to reduce radiation by destroying the base station need to make up their minds. Unless you don't use a phone, the weaker the base station, the stronger the signal radiation you receive.This is common sense.

  By the way, in the 5G era, if the same base station communicates with each other, the base station will no longer transmit data between them, but only send a matching control signal to let the two mobile phones transmit signals to each other.

  Any idea why? Because your mobile phone has more power than the base station, the signal transmission is stronger and more stable, and it also saves the resources of the base station, which is more cost-effective.